Turn off the printer.
Unplug the power cord from the electrical outlet, and then from the printer.
Unpack the internal solutions port (ISP) kit.
Note: Remove the preinstalled interface cable from the ISP.
1 | ISP |
2 | Mounting bracket |
3 | Thumbscrews |
4 | Housing |
5 | Interface cable |
Install the ISP into its housing.
Secure the ISP in place and attach the ISP extended cable.
Open, and then remove the controller board access cover.
Warning—Potential Damage:
Controller board electronic components are easily damaged by static electricity. Touch a metal surface on the printer before touching any controller board electronic components or connectors.
Attach the ISP kit to the printer.
If a printer hard disk is installed, then remove the hard disk before installing the ISP.
Unplug the hard disk interface cable from the controller board.
Connect the ISP extended cable to the ISP connector.
Install the hard disk.
Close the access cover.
Connect the power cord to the printer, and then to the electrical outlet.
CAUTION—POTENTIAL INJURY: To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.
Turn on the printer.