Font Source | Resident* Disk Download Flash Font Card All | Select the source which contains the default font selection. Notes: - Disk—appears only and if a non‑defective, non‑read/write protected hard disk that contains fonts is installed.
- Download—appears only if downloaded fonts exist in the printer memory.
- Flash—appears only if a non‑defective, non‑read/write protected flash memory that contains fonts is installed.
- Font Card—appears only if a valid font card is installed or an intelligent storage drive is configured.
|
Font Name | [List of available fonts] (Courier*) | Select a font from the specified font source. |
Symbol Set | [List of available symbol sets] (10U PC‑8*) | Specify the symbol set for each font name. Note: A symbol set is a set of alphabetic and numeric characters, punctuation, and special symbols. Symbol sets support the different languages or specific programs such as math symbols for scientific text. |
Pitch | 0.08–100.00 (10.00*) | Specify the pitch for fixed or monospaced fonts. Note: This menu item refers to the number of fixed‑space characters in a horizontal inch of type. |
Orientation | Portrait* Landscape Reverse Portrait Reverse Landscape | Specify the orientation of text and graphics on the page. |
Lines per Page | 1–255 | Specify the number of lines of text for each page printed through the PCL® data stream. Notes: - This menu item activates vertical escapement that causes the selected number of requested lines to print between the default margins of the page.
- 60 is the U.S. factory default setting. 64 is the international factory default setting.
|
PCL5 Minimum Line Width | 1–30 (2*) | Set the initial minimum stroke width value of any job printed in 1200 dpi through the applicable emulator. |
PCLXL Minimum Line Width | 1–30 (2*) |
A4 Width | 198
mm* 203
mm | Set the width of the logical page on A4‑size paper. Note: Logical page is the space on the physical page where data is printed. |
Auto CR after LF | On Off* | Set the printer to perform a carriage return after a line feed control command. Note: Carriage return is a mechanism that commands the printer to move the position of the cursor to the first position on the same line. |
Auto LF after CR | On Off* | Set the printer to perform a line feed after a carriage return control command. |
Tray Renumber | Assign MP Feeder Assign Tray [x] Assign Manual Paper Assign Manual Envelope | Configure the printer to work with a different print driver or custom application that uses a different set of source assignments to request a given paper source. Choose from the following options: - Off*—The printer uses the factory default paper source assignments.
- None—The paper source ignores the Select Paper Feed command.
- 0–199—Select a numeric value to assign a custom value to a paper source.
|
View Factory Defaults | Show the factory default value assigned for each paper source. |
Restore Defaults | Restore the tray renumber values to their factory defaults. |
Print Timeout | Off On* (90) | Set the printer to end a print job after it has been idle for the specified amount of time. |