Skip to Content Information Center
Lexmark CX833

Lexmark CX833

Not your product?

Installing an internal solutions port

CAUTION—SHOCK HAZARD:  To avoid the risk of electrical shock, if you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

Note:  This task requires a flat‑head screwdriver.

  1. Turn off the printer.

  2. Unplug the power cord from the electrical outlet, and then from the printer.

  3. Open the controller board access cover.

    Warning—Potential Damage:  Controller board electronic components are easily damaged by static electricity. Touch a metal surface on the printer before touching any controller board electronic components or connectors.

  4. Remove the internal solutions port (ISP) cover.

    Note:  Do not throw away the screw and cover.

  5. Unpack the ISP kit.

    1

    ISP

    2

    ISP extended cable

    3

    Mounting bracket

    4

    Thumbscrews

  6. Attach the mounting bracket to the controller board until it clicks into place.

  7. Attach the ISP to the mounting bracket, and then connect the ISP extended cable to its connector on the controller board.

  8. Secure the ISP to the printer.

  9. Close the controller board access cover.

  10. Connect one end of the power cord to the printer, and then the other end to the electrical outlet.

    CAUTION—POTENTIAL INJURY:  To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.

  11. Turn on the printer.
Was this article helpful?


Related content

Top