C73x/X73x – Paper Nicks and/or Creases
Bulletin# C73x_102 | Problem Description |
Machine Type/Model | C734 5026-210C734 5026-230C734 5026-280C736 5026-410C736 5026-430X734 7526-275X736 7526-476X738 7526-676 | Paper nicks and creases are seen on the lower right edge of the paper when printing from Tray 1. Solution Replace Tray 1 using CRU part number: 40X5273. When issue is seen when duplex printing, check if duplex settings is set correctly. |
Date Created | 04/21/10 |
Last Updated | 04/22/10 |
Safety Issue? | No |
Code Update? | No |
Engineering Change? | No |
New Parts? | Yes |
Old Parts Status | n/a |
Voltage: 120/240 | All |
Serial No. Range | All |
LEGACY ID: TE138
Overview
Your paper may print out creased or have nicks and/or tears. This damage happens regardless if you are printing simplex (i.e., single-sided) or duplex (i.e., on both sides) of the page.
Explanation
One of the following may be the cause of this issue:
-The paper is not correctly loaded in the paper tray. -You are printing on a special type of paper or other media. -There are obstructions in the path where the paper travels.Troubleshooting
Step | Action |
1 | Ensure that the paper is loaded properly into the tray. Verify that the guides are not putting too much pressure on the paper stack. Such pressure may cause the paper to curl as it feeds out of the tray. |
2 | Ensure the paper size and type on the printer settings match that of the paper loaded on the tray. |
3 | Verify if the printer supports the weight, size and type of the loaded paper. To see the supported paper sizes, types and weights of this printer, please refer to the printer's User's Guide. |
NOTE: If the issue continues after considering the steps above, a service action may be required to correct the issue. Please contact Lexmark Technical Support for additional information and suggestions.
Still need help?
Please contact Lexmark Technical Support if you need additional assistance.
NOTE: When calling for support, you will be asked for your machine/model type and serial number (SN). If you need help locating your printer's model type and serial number, How to Locate the Serial Number, TLI, Config ID, and Machine Type on the Lexmark C734, C736 or X734, X736, X738 Color Laser Printers.
Please call from near the printer in case the technician on the phone asks you to perform a task involving the printer.
LEGACY ID: TE138
Audience: Service Providers and Phone Support Representatives
Explanation
The paper nicks and creases can be seen on the lower-right edge of the printed paper when using Tray 1. It is suspected that the metal guide in Tray 1 is causing the problem.
Troubleshooting
Step | Action |
1 | Attempt to go through all of the customer-level checks before replacing any parts on the printer. |
2 | If the issue is present regardless whether they are printing in simplexor duplex, replace the Tray 1 with the newest level tray; i.e., CRU:40X5273. |
3 | If the issue ONLY happens when printing in duplex, make sure the Duplex settings is configured properly. To do this, log in to the printer’s Diagnostics mode.Procedure: Power off the printer. Press and hold the and arrow buttons.Power on the printer while pressing and holding these. Go to Duplex Test. Do a Quick Test/Continuous print to check if there is skew on the page and if the nicks are present. Change the skew under the Duplex Test menu if needed. It is recommended to change the Duplex skew to Positive value while still maintaining a good skew result to reduce/remove the nicks.
|
LEGACY ID: TE138