Roller marks on the rear side on pages
Overview
Roller marks are appearing on the back of the printed page that go away but return after calibration. See image sample below.
Print Defect Sample
This article will help you confirm the problem. Please refer to the directions in the table below to help determine which hardware part is causing the issue.
Troubleshooting
Steps | Actions |
1 | Run about 15 blank pages (or pages with just a few characters) to allow the rollers to clean itself. The marks should fade away over time. |
2 | If this does not resolve the issue, please contact Lexmark Technical Support for other troubleshooting suggestions. |
Contacting Lexmark
Please contact Lexmark Technical Support if you need additional assistance.
NOTE: When calling for support, you will be asked for your machine/model type and serial number (SN). If you need help locating your printer's model type and serial number, How to Locate the Serial Number, TLI, Config ID, and Machine Type on a Lexmark CS310, CS410, CS510, CX310, CX410, and CX510.
Please call from near the printer in case the technician on the phone asks you to perform a task involving the printer.
LEGACY ID: SO7213