| Set the printer to automatically switch to PCL emulation when a print job received through a USB port requires it, regardless of the default printer language. Notes: - On is the factory default setting.
- If PCL SmartSwitch is enabled, then the printer uses PostScript emulation.
- If PCL SmartSwitch is disabled, then the printer does not examine incoming data and it uses the default printer language specified in the Setup menu.
|
| Set the printer to automatically switch to PS emulation when a print job received through a USB port requires it, regardless of the default printer language. Notes: - On is the factory default setting.
- If PS SmartSwitch is enabled, then the printer uses PostScript emulation.
- If PS SmartSwitch is disabled, then the printer does not examine incoming data and it uses the default printer language specified in the Setup menu.
|
| Set the printer to perform the special processing required for bidirectional communication following the conventions defined by the NPA protocol. Notes: - Auto is the factory default setting. Auto sets the printer to examine data, determine the format, and then process it appropriately.
- The printer automatically restarts when changing the setting from the printer control panel. The menu selection is then updated.
|
USB Buffer - Disabled
- Auto
- 3K to [maximum size allowed]
| Set the size of the USB input buffer. Notes: - Auto is the factory default setting.
- Disabled turns off job buffering. Any jobs already buffered in the printer hard disk are printed before normal processing resumes.
- The USB buffer size value can be changed in 1KB increments.
- The maximum size allowed depends on the amount of memory in the printer, the size of the other link buffers, and whether Resource Save is enabled or disabled.
- To increase the maximum size range for the USB Buffer, disable or reduce the size of the parallel, serial, and network buffers.
- The printer automatically restarts when the setting is changed from the printer control panel. The menu selection is then updated.
|
| Set the printer to process Macintosh binary PostScript print jobs. Notes: - Auto is the factory default setting.
- On processes raw binary PostScript print jobs.
- Off filters print jobs using the standard protocol.
|
ENA Address - yyy.yyy.yyy.yyy
| Set the network address, netmask, and gateway information for an external print server. Note: This menu is available only when the printer is attached to an external print server through the USB port. |
ENA Netmask - yyy.yyy.yyy.yyy
|
ENA Gateway - yyy.yyy.yyy.yyy
|