Skip to Content Information Center
Lexmark B2650

Lexmark B2650

Detection Failure of Font, Forms Merge&Bar Code, Prescribe DLEs and Other Flash Card Options

Affected products

Click

Properties

in the title section above.

What you will see

Upon boot-up of the printer, the presence of an installed DLE or Font or Flash card is not indicated on the Menu Settings Page. Sometimes, the DLE or Font card is detected but “Flash MB” is missing under Installed Features.

Rebooting the printer several times may eventually allow the DLE, Font, or Flash card to be recognized on the Menu Settings Page.

Solution

  1. Make sure the DLE or Font or Flash card is securely seated in its appropriate slot or socket.

  2. Update firmware to FW5.2.24, or ######.052.024 or later. See KB ID:xref_HO550_xref for update instructions.

  3. If the issue continues to be seen after updating firmware, please contact Lexmark Technical Support. Provide this article ID# SO8693 to the support representative.

Explanation

Numerous system interactions, or timing between parallel processes and hardware detection, is causing an intermittent race condition. This race condition is preventing the optional card from being detected within a specific timeframe during the boot-up sequence.

Stll need help?

If you need additional assistance, please close this browser tab or go to the Lexmark support site, type your printer model and locate

Get in Touch with Lexmark! for contact information.
NOTE:
When calling for support, you will need the following:

  • Affected printer model/s
  • Printer serial number

Please be near the product/s described in this article to expedite the support process and reduce callbacks.

LEGACY ID: SO8693

LEGACY ID: SO8693

War dieser Artikel hilfreich?
Top