Skip to Content Information Center
Lexmark C9235

How to Install the 'IEEE-1284B Parallel' ISP Option Card on the T65x, C73x, X65x, X65x, CX92x Series Printers and MFPs

Before you begin

Make sure that no held jobs are present in the print queue. Then power off the device. Remove the left-hand access door and remove the metal shield that a Phillips screw holds in place.IMPORTANT: Failureto remove held jobs may resultin a 57 Configuration change, some held jobs were not restored message. Lost jobs are not recoverable.

Installing ISP* option (Parallel card example)

Other card types: MarkNet N8230 Fiber, the External RS-232Cserial option, and other supported options all install in a similar manner. CS/CX 92x illustration showing installed ISP 'MarkNet option'

StepAction

Illustration

1Remove the IEEE-1284B Parallel Option card from its package and confirm the shipped contents:
  • Parallel card with ISP cable
  • Card mounting bracket ( or T-bracket)
  • Thumbscrews

ISP* - Internal solutions port

No Image

2

Required if HD present

If a hard drive (HD) is present on the printer, you will need to remove the existing hard drive from the device before proceeding. To do this:
  1. Remove the two outside screws from the back of the printer.

  2. Disconnect the existing hard drive cable from the system board.

  3. Remove the two thumbscrews from the anchor plate.

NOTE: If your printer does not contain a hard drive, you will still have to remove the two screws from the option card slot on the back of the printer.

3

Required if HD present

Remove the hard drive. Observe the location of the three mounting posts and the corresponding mounting hole positions on the system board.
4If the purchased option provides a T-bracket, then snap it into place.
5

Slide the card into preliminary position. Start the upper bracket thumb screw into the T- bracket, but do not tighten it all the way.

Suggestion: Do not install the lower bracket thumb screw at this time for alignment purposes. Also, the bail clips should stick straight out to allow passage through the card cage slot.

6Center and insert the top slot screw. Also, make sure the bottom of the card is center-aligned with the the control cage's screw position.
7

Place the parallel card onto the T-bracket and secure this card with the longer thumbscrew that has been included.

IMPORTANT! Do not over tighten; and make sure the card is centered in the bracket.

8Insert and tighten both lower-bracket thumb screw and lower-slot screw.

Lower-slot screw illustration.

9Lastly, connect the card's blue cable connector to the system board socket labeled INA or ISP.

10

Required if HD present

If you are reinstalling the hard drive, align the hard drive mounting posts with the corresponding card holes. Then snap the hard drive back into place.

11

Required if HD present

Connect the hard drive cable connector to the blue socket on the parallel card labeled HDD.
.
12Replace all covers. No Image

Additional installation articles


NOTE:

Installation instructions can slighly vary by printer model.

xref_HO3440_xref

Still need help?

If you need additional assistance, please go to the Lexmark support site, type your printer model and locate

Get in Touch with Lexmark! for contact information.
NOTE:
When calling for support, you will need the following:

  • Printer model
  • Printer serial number
  • Name of application or solution software

Please be near the product/s described in this article to expedite the support process and reduce callbacks.

LEGACY ID: HO3629

Cet article vous a-t-il été utile ?
Top