Skip to Content Information Center
Lexmark MS811

Lexmark MS811

Black vertical lines when copying, scanning and faxing

Issue description

Single or multiple vertical lines of toner appear on a copied page, scanned image or sent fax page. The lines will be vertical but the image might be skewed or angled because it was sent through the Auto Document Feeder (ADF) portion of the scanner.

The lines will not be present if you send a document to print directly to the printer, but will appear if you make a copy the same document. The lines could be on one or both sides of a duplex scan.

Possible causes

The glass plates in the ADF scanner portion have some foreign debris blocking the lens of the scanner, thus creating a vertical streak in that position during copying, faxing, or scanning. The likely contamination is from paper debris, staples, chads, residual whiteout tape or paste, gel ink, or adhesive material.

Solution

To resolve this issue, refer to “Cleaning the scanner glass” and check if the issue persists.

Service Action

Recommend the SVC Bezel Cleaning Kit, Part number: 41X1007, when setting up service.

Note:  Use the wet wipe first to loosen and clean most of the debris, followed by the dry wipe to remove any residual film that might be left from the initial cleaning.

Should there be additional concerns or questions, contact the next level of support for further diagnosis.

LEGACY ID: SO8161

Was this article helpful?
Top