Skip to Content Information Center
Lexmark MS610dn / MS610dtn

Lexmark MS610dn / MS610dtn

202.45 Paper Jam Error Code

Defect Symptom

202.45 Paper Jam – The sheet was detected too long over exit sensor. Check for possible accordion jam, stuck exit sensor, or several overlapped sheets that were left in the paper path after a jam.

Customer Repair Action & Troubleshooting

  1. Make sure that there is no paper in the Fuser – open Rear Door and look at back of Fuser; the Exit Sensor is in the center of the path. Remove paper if necessary. A torn sheet may be lodged in the Fuser, thus holding the sensor down.

  2. The Fuser must be replaced if the torn sheet cannot be removed.

Repair Sequence 1 (Copy into Siebel)

  1. Replace Fuser.

IMPORTANT! For MS51x, MS61x, MX51x, & MX61x, end of life consumables such as fuser, transfer roll, and/or pick tires can cause some errors. Check the fuser's status using the printer's Control Panel or . The customer will have to order a maintenance kit if a fuser enters a 'beyond life' state within the printer's warranty period.

Parts repair 1

Choose appropriate Fuser: 40X8343 – Fuser, 100V 40X8023 – Fuser, 110V 40X8024 – Fuser, 220V

Repair sequence 2 (Copy into Siebel)


Parts repair 2



¿Este artículo ha sido útil?