202.45 Paper Jam – The sheet was detected too long over exit sensor. Check for possible accordion jam, stuck exit sensor, or several overlapped sheets that were left in the paper path after a jam.Customer Repair Action & Troubleshooting
Repair Sequence 1 (Copy into Siebel)
Make sure that there is no paper in the Fuser – open Rear Door and look at back of Fuser; the Exit Sensor is in the center of the path. Remove paper if necessary. A torn sheet may be lodged in the Fuser, thus holding the sensor down.
The Fuser must be replaced if the torn sheet cannot be removed.
IMPORTANT! For MS51x, MS61x, MX51x, & MX61x, end of life consumables such as fuser, transfer roll, and/or pick tires can cause some errors. Check the fuser's status using the printer's Control Panel or . The customer will have to order a maintenance kit if a fuser enters a 'beyond life' state within the printer's warranty period.Parts repair 1
Choose appropriate Fuser: 40X8343 – Fuser, 100V 40X8023 – Fuser, 110V 40X8024 – Fuser, 220VRepair sequence 2 (Copy into Siebel)
N/AParts repair 2
LEGACY ID: SO7301