Skip to Content Information Center
Lexmark CS827

Lexmark CS827

How to set up the envelope tray for first time use

Issue description

This article provides a guide on how to set up an envelope tray (Tray 3) on the printer.

Solution

Setting up envelope tray for first time use

Notes:

  • The printer firmware needs to be at least the FW4 (base=CXTPP.040.087 and engine=YK.040.E015) level code.
  • Please refer to Firmware Update Instructions for more information.

Note: 

  1. Check the printer firmware.

    • If the printer firmware level meets the above requirements (at least FW4), skip Steps3 and 4.
    • If there is an SPR (Special Product Request) firmware on the printer, it needs to be at least at the FW 4 level.
    • If the printer's SPR firmware is older than FW4, please contact Lexmark Technical Support for further assistance.
  2. Follow the setup guide to position the input tray on the printer. Important!The envelope tray must be in the Tray 3 location.

    Note:  The tray part number 21K0787 is labeled on its box.

  3. Download the most recent firmware for the printer

    Note:  Refer to the Drivers & downloads website

  4. Update the printer firmware by following the steps found in the README_Updating_Firmware document

  5. Download the tray firmware and load it to the printer by following the procedures found in the README_Updating_Firmware document.

  6. The envelope tray is now ready to use.

If the issue persists, search for more information related to this issue or contact support for further assistance.

LEGACY ID: HO4112

Was this article helpful?
Top