Overview
This article outlines the proper handling and replacement procedure of the Photoconductor Unit (PCU) for a Lexmark X86xe MFP.
Replacement/Installation Procedure
| Steps | Action | Image |
| 1 | Open the Front Door.
Note: The photoconductor cannot be pulled out if Side Door A is closed.
| |
| 2 | Lower Side Door A. | |
| 3 | Pull the photoconductor out of the MFP. Warning—Potential Damage: To avoid overexposing the photoconductor, do not leave the door open for more than ten minutes. Also place the photoconductor on a flat, clean surface. | |
| 4 | Unpack the new photoconductor unit. Warning! In order to avoid contamination, do not touch the blue, shiny surface of the drum. | |
| 5 | Align and insert the end of photoconductor unit. | |
| 6 | Remove the tape from the top of the photoconductor unit. Caution! Do not use a sharp object to remove the tape because it may damage the photoconductor unit. | |
| 7 | Push the photoconductor in as far as it will go.
Note: The photoconductor clicks into place when correctly installed.
| |
| 8 | Close Side Door A. | |
| 9 | Close the Front Door.
Note: After performing the steps above, the MFP performs a motor cycle and clears the Replace Photoconductor warnings. Then the MFP returns to the Ready state.
| |
Still Need Help?
Please contact Lexmark Technical Support if you need additional assistance.
NOTE: When calling for support, you will be asked for your machine/model type and serial number (SN). If you need help locating these, How to Locate the Serial Number, Machine Type, Part Number and Config ID on the Lexmark X86xe Series Printer.
Please call from near the printer in case the technician on the phone asks you to perform a task involving the printer.
LEGACY ID: HO3847