ENUS33018What you will see
The printer or MFP stops printing when an intervention request or attendance message is displayed on the LCD. Suggested Remedy
Activation of the Print Recovery/Auto Continue feature. This default setting is disabled.This feature can be turned on via operator panel or embedded web server. Operator panel:X658 MFP example
Press General Settings.
Press the down-arrow ~four times until you see Print Recovery.
Press the corresponding button next to Print Recovery.
Next to Auto Continue, press the right or left-arrow buttons to adjust the time*.
Press Submit. Click here for illustration.
* The amount of time (five-255 sec.) the attendance message is displayed before being suppressed and allowing for the print job's completion. Print results may vary depending on attendance message. NOTE: Other MFP and printer models carry this feature. The general path for most printers: Menu > Settings > General Settings > Print Recovery > Auto Continue. Embedded Web Server:X658 MFP example
Possible Auto Continuable Messages Table Reference
Enter the TCP/IP address of the MFP/printer into the URL field; e.g., http://MFP_IP_ADDRESS.
Click on Settings(Configuration) .
Click on General Settings.
Scroll down to the bottom of the page and select Print Recovery.
Adjust the time.
NOTE: This list is provided as reference only. MFP and printer features dictate the type intervention request or attendance message that is displayed on the operator panel or LCD. These attendance messages should be attendeded to as soon as possible.
|Held Jobs May Not Be Restored|
|Held Jobs May Not Be Restored (37 Insufficient Memory)|
|Held Jobs May Not Be Restored (57 Configuration Change)|
|Insert Staple Cartridge|
|PJL OP Message|
|PJL Seed Message|
|PJL ST Message|
|Restore Held Jobs Go/Stop|
|34 Short Paper|
|35 Res.(Resource) Save Off Deficient Memory|
|37 Insufficient Collation Area|
|37 Insufficient Memory|
|38 Memory Full|
|39 Complex Page|
|42 Cartridge Region Mismatch|
|50 PPDS Font Error|
|51 Defective Flash|
|52 Flash Full|
|54 Serial Option (X) Error|
|54 Network (X) Software Error|
|56 Parallel Port (X) disabled|
|56 Serial Port (X) disabled|
|56 USB Port (X) disabled|
|58 Too many bin attached|
|58 Too many disks installed|
|62 Disk Full|
|80 Routine maintenance. |
If you need additional assistance, please contactLexmark Technical Support.NOTE: When calling for support, you will be asked for your machine/model type and serial number (SN).Please call from near a computer and printer in case the technician on the phone asks you to perform a task involving one or all of these devices.
LEGACY ID: SO4808