Power off the printer, power it back on, and then check for any indicator or blinking lights on the printer's control panel.
Check the printer's network port as to whether it has a blinking or steady light.
Check for any gear noise upon powering up the printer by listening to it for a minute. The printer normally goes through a short warm-up sequence where it sounds as though it is going to print out a page.
- If the printer's operator panel is blank yet you hear the printer power up as normal, try printing a page from your computer. If the page prints, the printer is still receiving power. However, the control panel is not functioning and will likely need to be replaced. Please contact Lexmark Technical Support as a service call may be required.
Note: If the page prints correctly, you can continue using the printer in the meantime via computer.
Check for any fan noise or activity in the printer.
If the printer's power cord is plugged into a surge protector or uninterruptible power supply (UPS), unplug it and connect it directly to a grounded wall outlet. Some of these devices can interfere with consistent electrical flow and cause the printer to fail to power up properly.
Important! Also disconnect any data cables (i.e., parallel, USB, Ethernet) from the rear of the printer before testing it. Any defect in a data cable may cause an electrical short circuit that could result in a loss of power to the printer.
If the printer is plugged directly to the wall outlet, plug it into another known good power source. If the printer still fails to power up, verify that the wall outlet is working properly by connecting another device to it to see whether it receives power, or try another grounded outlet.
Should there still be no power, please contact Lexmark Technical Support as a service call may be required.