Skip to Content Information Center
Lexmark X954

Lexmark X954

Lexmark X95x MFP ? Intermittent 900.58 Error Code Is Displayed when Scanning or Copying After First Boot Up


When attempting to scan/copy using the Auto Document Feeder (ADF) or Flatbed Scanner, the machine will post a 900.58 error code.

Additional Identifiers

This issue will only happen during the first boot up or power up. Usually the problem occurs in the morning because the printer was turned off overnight.

If issue appears only when using the flatbed scanner to copy, and the scanner lamp only moves about two inches (five cm) when a scan is initiated and then posts the 900.58 error code, please visit Knowledgebase Article ID: 843.05 and 900.58 Error Code.


  1. Clear the error by powering off the MFP. Wait ten to 20 seconds before powering it back on. Run a test scan and see whether the error reappears.

  • If the error did not reappear after a couple of test scans, continue using the machine but observe its operation for a week. If no further sign of the error develops, it was probably a temporary glitch; restarting the machine cleared it.
  • If the error re-appears, update the printer’s firmware with the latest PE release code LHS30.TQ.P345 or higher.

Please contact Lexmark Technical Support to obtain this firmware.

Still Need Help?

If you require additional assistance, please close this window and locate

Get in Touch with Lexmark! for contact information.
When calling for support, you will be asked for your machine/model type and serial number (SN). If you need help locating your printer's model type and serial number, How to Locate the Serial Number, Machine Type, and Configuration ID on a Lexmark C950 or X95x Printer/MFP.

Please be near the products described in this article to expedite the support process and reduce callbacks.


Was this article helpful?