Skip to Content Information Center
Lexmark CS317

Lexmark CS317

Universal Setup menu

UseTo

    Units of Measure

  • Inches
  • Millimeters

Identify the units of measure.

Notes:

  • Inches is the U.S. factory default setting.
  • Millimeters is the international factory default setting.

    Portrait Width

  • 3–14.17  inches
  • 76–360  mm

Set the portrait width.

Notes:

  • If the width exceeds the maximum, then the printer uses the maximum width allowed.
  • 8.5  inches is the U.S. factory default setting. You can increase the width in 0.01‑inch increments.
  • 216  mm is the international factory default setting. You can increase the width in 1‑mm increments.

    Portrait Height

  • 3–14.17  inches
  • 76–360  mm

Set the portrait height.

Notes:

  • If the height exceeds the maximum, then the printer uses the maximum height allowed.
  • 14  inches is the U.S. factory default setting. You can increase the height in 0.01‑inch increments.
  • 356  mm is the international factory default setting. You can increase the height in 1‑mm increments.

    Feed Direction

  • Short Edge
  • Long Edge

Specify the feed direction if the paper can be loaded in either direction.

Notes:

  • Short Edge is the factory default setting.
  • Long Edge appears only when the longest edge is shorter than the maximum width supported in the tray.
Was this article helpful?
Top