Skip to Content Information Center
Lexmark CS510

Lexmark CS510

Removing a printer hard disk

    Note:  This task requires a flathead screwdriver.

    CAUTION—SHOCK HAZARD:  If you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

    Warning—Potential Damage:  Controller board electronic components are easily damaged by static electricity. Touch something metal on the printer first before touching any controller board electronic components or connectors.

  1. Access the controller board.

    For more information, see Accessing the controller board.

  2. Unplug the printer hard disk interface cable from the controller board, leaving the cable attached to the printer hard disk. To unplug the cable, squeeze the paddle at the plug of the interface cable to disengage the latch before pulling the cable out.

  3. Remove the printer hard disk by pulling it away from the controller board.

  4. Set aside the printer hard disk.

  5. Close the controller board access cover.

Was this article helpful?