| Set the printer to automatically switch to PCL emulation when a print job received through a USB port requires it, regardless of the default printer language. Notes: - On is the factory default setting.
- When set to Off, the printer does not examine incoming data. The printer uses PostScript emulation if the PS SmartSwitch is set to On. It uses the default printer language specified in the Setup menu if the PS SmartSwitch is set to Off.
|
| Set the printer to automatically switch to PS emulation when a print job received through a USB port requires it, regardless of the default printer language. Notes: - On is the factory default setting.
- When set to Off, the printer does not examine incoming data. The printer uses PCL emulation if the PCL SmartSwitch is set to On. It uses the default printer language specified in the Setup menu if the PCL SmartSwitch is set to Off.
|
| Set the printer to perform the special processing required for bidirectional communication following the conventions defined by the NPA protocol. Notes: - Auto is the factory default setting. Auto sets the printer to examine data, determine the format, and then process it appropriately.
- The printer automatically restarts when changing the setting from the printer control panel. The menu selection is then updated.
|
USB Buffer - Disabled
- Auto
- 3K to
[maximum size allowed]
| Set the size of the USB input buffer. Notes: - Auto is the factory default setting.
- Disabled turns off job buffering.
- The USB buffer size value can be changed in 1-KB increments.
- The maximum size allowed depends on the amount of memory in the printer, the size of the other link buffers, and whether Resource Save is set to On or Off.
- To increase the maximum size range for USB Buffer, disable or reduce the size of the parallel, serial, and network buffers.
- The printer automatically restarts when the setting is changed from the printer control panel. The menu selection is then updated.
|
| Set the printer to process Macintosh binary PostScript print jobs. Notes: - Auto is the factory default setting.
- On processes raw binary PostScript print jobs.
- Off filters print jobs using the standard protocol.
|
ENA Address - yyy.yyy.yyy.yyy
| Set the network address information for an external print server. Note: This menu is available only when the printer is attached to an external print server through the USB port. |
ENA Netmask - yyy.yyy.yyy.yyy
| Set the netmask information for an external print server. Note: This menu is available only when the printer is attached to an external print server through the USB port. |
ENA Gateway - yyy.yyy.yyy.yyy
| Set the gateway information for an external print server. Note: This menu is available only when the printer is attached to an external print server through the USB port. |