Skip to Content Information Center
Lexmark MX610

Lexmark MX610

Accessing the controller board

    CAUTION—SHOCK HAZARD:  If you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

  1. Open the controller board access door.

  2. Open the controller board shield using the green handle.

  3. Use the following illustration to locate the appropriate connector.

    Warning—Potential Damage:  Controller board electronic components are easily damaged by static electricity. Touch something metal on the printer before touching any controller board electronic components or connectors.


    Memory card connector


    Option card connector


    Printer hard disk connector


    Lexmark Internal Solutions Port connector

  4. Close the shield, and then the access door.

Was this article helpful?