Skip to Content Information Center
Lexmark MX710

Lexmark MX710

Nie je toto váš výrobok?

Creating a custom copy job

The custom copy job or job build is used to combine one or more sets of original documents into a single copy job. Each set may be scanned using different job parameters. When a copy job is submitted and Custom Job is enabled, the scanner scans the first set of original documents using the specified settings, and then it scans the next set with the same or different settings.

The definition of a set depends on the scan source:

  • If you scan a document on the scanner glass, then a set consists of one page.
  • If you scan multiple pages using the ADF, then a set consists of all scanned pages until the ADF tray becomes empty.
  • If you scan one page using the ADF, then a set consists of one page.

For example:

  1. Load an original document faceup, short edge first into the ADF tray or facedown on the scanner glass.

    Notes:

    • Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine clippings) into the ADF tray. Place these items on the scanner glass.
    • The ADF indicator light comes on when the paper is loaded properly.

  2. If you are loading a document into the ADF tray, then adjust the paper guides.

  3. From the home screen, navigate to:

    Copy > Advanced Options > Custom Job > On >  > Copy It

    Note:  When the end of a set is reached, the scan screen appears.

  4. Load the next document faceup, short edge first into the ADF tray or facedown on the scanner glass, and then touch Scan from automatic feeder or Scan from flatbed.

    Note:  Change the scan job settings, if necessary.

  5. If you have another document to scan, then repeat the previous step. Otherwise, touch Finish the job.
Pomohol vám tento článok?
Top