Skip to Content Information Center
Lexmark CX923

Lexmark CX923

Replacing the pick, feed, and separator rollers

1

Pick roller

2

Feed roller

3

Separator roller

  1. Turn off the printer.

  2. Remove all the trays.

    • Standard tray
    • Optional 2500‑sheet tray
    • Notes:

      • Use the screwdriver stored inside door A.
      • To remove the optional 2 x 500‑sheet tray, follow the procedure in removing the standard tray.
  3. Open door C.

    Notes:

    • Make sure that the door does not hit any cable attached to the printer.
    • If a 3000‑sheet tray is installed, then slide the tray to the right to open the door.

    CAUTION—HOT SURFACE:  The inside of the printer might be hot. To reduce the risk of injury from a hot component, allow the surface to cool before touching it.

  4. Open door D.

    Notes:

    • Door D is only accessible if an optional 2500‑ or 2 x 500‑sheet tray is installed.
    • If a 3000‑sheet tray is installed, then slide the tray to the right to open the door.
  5. Locate the rollers.

  6. Remove the rollers.

  7. Insert the new rollers until they click into place.

    Note:  Make sure to insert the rollers to their proper places.

  8. Close doors D and C.

  9. Insert the trays, and then turn on the printer.

Was this article helpful?
Top