Skip to Content Information Center
Lexmark MX522

Lexmark MX522

Installing an internal solutions port

CAUTION—SHOCK HAZARD:  To avoid the risk of electrical shock, if you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

  1. Turn off the printer.

  2. Unplug the power cord from the electrical outlet, and then from the printer.

  3. Unpack the internal solutions port (ISP) kit.

    Note:  Remove the preinstalled interface cable from the ISP.




    Mounting bracket






    Interface cable

  4. Install the ISP into its housing.

  5. Secure the ISP in place and attach the ISP extended cable.

  6. Open, and then remove the controller board access cover.

    Warning—Potential Damage:  Controller board electronic components are easily damaged by static electricity. Touch a metal surface on the printer before touching any controller board electronic components or connectors.

  7. Attach the ISP kit to the printer.

    If a printer hard disk is installed, then remove the hard disk before installing the ISP.

    1. Unplug the hard disk interface cable from the controller board.

    2. Connect the ISP extended cable to the ISP connector.

    3. Install the hard disk.

  8. Close the access cover.

  9. Connect the power cord to the printer, and then to the electrical outlet.

    CAUTION—POTENTIAL INJURY:  To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.

  10. Turn on the printer.

Was this article helpful?