Skip to Content Information Center
Lexmark MS825

Lexmark MS825

Selecting a location for the printer

When selecting a location for the printer, leave enough room to open trays, covers, and doors and to install hardware options.

  • Set up the printer near an electrical outlet.
  • CAUTION—POTENTIAL INJURY:  To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.

    CAUTION—SHOCK HAZARD:  To avoid the risk of electrical shock, do not place or use this product near water or wet locations.

  • Make sure that airflow in the room meets the latest revision of the ASHRAE 62 standard or the CEN Technical Committee 156 standard.
  • Provide a flat, sturdy, and stable surface.
  • Keep the printer:
    • Clean, dry, and free of dust.
    • Away from stray staples and paper clips.
    • Away from the direct airflow of air conditioners, heaters, or ventilators.
    • Free from direct sunlight and humidity extremes.
  • Observe the recommended temperatures and avoid fluctuations:
  • Ambient temperature

    10 to 32.2°C (50 to 90°F)

    Storage temperature

    -40 to 43.3°C (-40 to 110°F)
  • Allow the following recommended amount of space around the printer for proper ventilation:
  • 1


    152 mm (6 in.)


    Right side

    152 mm (6 in.)



    406 mm (16 in.)
    The minimum space needed in front of the printer is 76 mm (3 in.).


    Left side

    152 mm (6 in.)



    152 mm (6 in.)
Updated November 2015
Was this article helpful?