Skip to Content Information Center
Lexmark MS825

Lexmark MS825

Installing the 250‑ or 550‑sheet tray

    CAUTION—SHOCK HAZARD:  To avoid the risk of electrical shock, if you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

    CAUTION—TIPPING HAZARD:  Installing one or more options on your printer or MFP may require a caster base, furniture, or other feature to prevent instability causing possible injury. For more information on supported configurations, see www.lexmark.com/multifunctionprinters.

  1. Turn off the printer.

  2. Unplug the power cord from the electrical outlet, and then from the printer.

  3. Unpack the optional tray, and then remove all packing material.

    Note:  If optional trays are already installed, then unlock them from the printer before lifting the printer. Do not try to lift the printer and trays at the same time.

  4. Align the printer with the optional tray, and then lower the printer until it clicks into place.

    CAUTION—POTENTIAL INJURY:  If the printer weight is greater than 18  kg (40  lb), then it requires two or more trained personnel to lift it safely.

  5. Connect the power cord to the printer, and then to the electrical outlet.

    CAUTION—POTENTIAL INJURY:  To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.

  6. Turn on the printer.

Add the tray in the print driver to make it available for print jobs. For more information, see Adding available options in the print driver.

Updated December 2017
Was this article helpful?
Top