Skip to Content Information Center
Lexmark CS521

Lexmark CS521

Installing a printer hard disk

    CAUTION—SHOCK HAZARD:  To avoid the risk of electrical shock, if you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

  1. Turn off the printer.

  2. Unplug the power cord from the electrical outlet, and then from the printer.

  3. Using a flat‑head screwdriver, remove the controller board access cover.

    Warning—Potential Damage:  Controller board electronic components are easily damaged by static electricity. Touch a metal surface on the printer before touching any controller board components or connectors.

  4. Using a flat‑head screwdriver, remove the hard disk port cover from the controller board access cover.

  5. Unpack, and then assemble the hard disk.

  6. Attach the hard disk to the controller board access cover.

  7. Connect the hard disk interface cable to the controller board, and then attach the access cover.

  8. Connect the power cord to the printer, and then to the electrical outlet.

    CAUTION—POTENTIAL INJURY:  To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.

  9. Turn on the printer.

Was this article helpful?
Top