PCL

Font Source

• Resident*
• Disk
• Download
• Flash
• Font Card
• All

Select the source which contains the default font selection.

Notes:

• Disk and Flash appear only when a non-defective, non-protected hard disk or intelligent storage drive (ISD) that contains fonts is installed.
• Download appears only if downloaded fonts exist in the printer memory.
• Font Card appears only when an ISD is installed.

Font Name

• [List of available fonts] (Courier*)

Select a font from the specified font source.

Symbol Set

• [List of available symbol set] (10U PC‑8*)

Specify the symbol set for each font name.

Note:  A symbol set is a set of alphabetic and numeric characters, punctuation, and special symbols. Symbol sets support the different languages or specific programs such as math symbols for scientific text.

Pitch

• 0.08–100.00 (10.00*)

Specify the pitch for fixed or monospaced fonts.

Note:  Pitch refers to the number of fixed‑space characters in a horizontal inch of type.

Orientation

• Portrait*
• Landscape
• Reverse Portrait
• Reverse Landscape

Specify the orientation of text and graphics on the page.

Lines per Page

• 1–255

Specify the number of lines of text for each page printed through the PCL® data stream.

Notes:

• This menu item activates vertical escapement that causes the selected number of requested lines to print between the default margins of the page.
• 60 is the U.S. factory default setting. 64 is the international factory default setting.

PCL5 Minimum Line Width

• 1–30 (2*)

PCLXL Minimum Line Width

• 1–30 (2*)

A4 Width

• 198 mm*
• 203 mm

Set the width of the logical page on A4‑size paper.

Note:  Logical page is the space on the physical page where data is printed.

Auto CR after LF

• On
• Off*

Set the printer to perform a carriage return after a line feed control command.

Note:  Carriage return is a mechanism that commands the printer to move the position of the cursor to the first position on the same line.

Auto LF after CR

• On
• Off*

Set the printer to perform a line feed after a carriage return control command.

Tray Renumber

• Assign Tray [x]
• Assign Manual Paper
• Assign Manual Envelope

Configure the printer to work with a different print driver or custom application that uses a different set of source assignments to request a given paper source.

Tray Renumber

• View Factory Defaults

Show the factory default value assigned for each paper source.

Tray Renumber

• Restore Defaults

Restore the tray renumber values to their factory defaults.

Print Timeout

• Off
• On* (90 seconds)

Set the printer to end a print job after it has been idle for the specified amount of time.