Font Source - Resident*
- Disk
- Download
- Flash
- All
| Select the source which contains the default font selection. Notes: - Disk and Flash appear only when a non‑defective, non‑protected hard disk or flash memory that contains fonts is installed.
- Download appears only if downloaded fonts exist in the printer memory.
|
Font Name - [List of available fonts] (Courier*)
| Select a font from the specified font source. |
Symbol Set - [List of available symbol set] (10U PC‑8*)
| Specify the symbol set for each font name. Note: A symbol set is a set of alphabetic and numeric characters, punctuation, and special symbols. Symbol sets support the different languages or specific programs such as math symbols for scientific text. |
Pitch - 0.08–100.00 (10.00*)
| Specify the pitch for fixed or monospaced fonts. Note: Pitch refers to the number of fixed‑space characters in a horizontal inch of type. |
Orientation - Portrait*
- Landscape
- Reverse Portrait
- Reverse Landscape
| Specify the orientation of text and graphics on the page. |
| Specify the number of lines of text for each page printed through the PCL® data stream. Notes: - This menu item activates vertical escapement that causes the selected number of requested lines to print between the default margins of the page.
- 60 is the U.S. factory default setting. 64 is the international factory default setting.
|
PCL5 Minimum Line Width - 1–30 (2*)
| Set the initial minimum stroke width. |
PCLXL Minimum Line Width - 1–30 (2*)
|
| Set the width of the logical page on A4‑size paper. Note: Logical page is the space on the physical page where data is printed. |
| Set the printer to perform a carriage return after a line feed control command. Note: Carriage return is a mechanism that commands the printer to move the position of the cursor to the first position on the same line. |
| Set the printer to perform a line feed after a carriage return control command. |
Tray Renumber - Assign MP Feeder
- Assign Tray [x]
- Assign Manual Paper
- Assign Manual Envelope
| Configure the printer to work with a different print driver or custom application that uses a different set of source assignments to request a given paper source. |
Tray Renumber - View Factory Defaults
| Show the factory default value assigned for each paper source. |
Tray Renumber - Restore Defaults
| Restore the tray renumber values to their factory defaults. |
Print Timeout - Off
- On* (90 seconds)
| Set the printer to end a print job after it has been idle for the specified amount of time. |