CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.
Notes:
- This option can also be installed together with a staple, hole punch finisher or booklet finisher.
- This task requires a flat‑head screwdriver.
Turn off the printer.
Unplug the power cord from the electrical outlet, and then from the printer.
Unpack the paper transport with folding option, and then remove all the packing material.
Remove the standard bin.
Note: Do not throw away the bin.
Before installing the option, place the exit bin flag into the closed position.
Note: When the option is removed, place the exit bin flag into the open position.
Remove the backup roller.
Note: Do not throw away the roller.
Insert the feed roller that came with the option until it clicks into place.
Note: Make sure that the metal spring is in front of the feed roller.
Attach the roller cover until it clicks into place.
Open the front door, and then remove the cover on the left side of the printer.
Note: Do not throw away the screw and cover.
Close the front door.
Remove the paper transport connector cover.
Note: Do not throw away the cover.
Remove the left rear cover.
Note: Do not throw away the screw and cover.
Remove the inner bin cover.
Note: Do not throw away the screw and cover.
Align, and then insert the inner bin cover that came with the option.
Install the screws to the inner bin cover.
Attach the pieces of foam tape to the option.
Open door F, and then tighten the screws.
Close door F.
Attach the metal bracket to the option.
Insert the option.
Note: Make sure that the metal bracket is in front of the printer.
Open door F, and then using the screwdriver that came with the option, install the screw.
Close door F.
Install the screws into the option.
Attach the left rear cover.
Open the front door, and then attach the cover to the left side of the printer.
Close the front door.
Raise the bin flap, and then align and attach the option bin.
Install the screws to the option bin.
Attach the trim cover.
Connect the option cable to the printer.
Connect one end of the power cord to the printer, and then the other end to the electrical outlet.
CAUTION—POTENTIAL INJURY: To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.
Turn on the printer.