Skip to Content Information Center
Lexmark MX410

Lexmark MX410

Unable to Close the Front Door of a Lexmark MS310, MS410, MS510, MS610, MX310, MX410, MX510, MX511, MX610, & MX611 Printer/MFP

What you will see

You are unable to close or have difficulty closing the printer’s front cover.

Explanation

The front door will not close if the cartridge is not fully seated. This can happen if the cartridge is slowly installed into the printer but not fully seated/installed.

A cartridge retainer finger protrudes from the guide rail when the front cover closes. (See image below.) If a cartridge is not fully installed, the retainer cannot be actuated and the front door cannot close.

Click Image to Enlarge
Right-side view of the cartridge: The red arrow points the retainer finger.


NOTE:
This failure is the desired function. By design, the printer should not work if the cartridge is not fully installed.

Recommended solution

  1. Open the printer's front door.

  2. Remove the Toner Unit. Check whether any obstructions are inside; clear the obstruction if one exists.

  3. Re-insert the toner and make sure that it is seated properly.

  4. Close the door and see whether the printer will go on Ready mode.

  5. If the message persists, the Door Open Switch might be damaged. Contact Lexmark Technical Support to set up service.

Still need help?

Please contact Lexmark Technical Support if you need additional assistance.
NOTE:
When calling for support, you will be asked for your machine/model type and serial number (SN). If you need help locating these, xref_HO3864_xref.

Please call from near the printer in case the technician on the phone asks you to perform a task involving the printer.

LEGACY ID: SO7141

¿Este artículo ha sido útil?
Top