Remove the controller board shield. See Controller board shield removal.
Remove the inner controller board shield. See Inner controller board shield removal.
Remove the left cover. See Left cover removal.
Remove the ADF. See ADF removal.
Remove the scanner tilt. See Scanner tilt removal.
Disconnect the flatbed CCD cable (A) from the controller board.
Warning—Potential Damage: Do not yank the ribbon cable. See Disconnecting ribbon cables.
Remove the output bin cover. See Output bin cover removal.
Pull up the cable to create some slack, and then pull the tab (B) to slide the toroid out of the retainer.
Pull the cable through the retainer.
Route the cable through the frame and to the left side of the printer.
Disconnect the two cables (C) on the controller board.
Route the cables through the frame and to the left side of the printer.
Remove the cotter pin (D) on the right side of the flatbed.
Remove the cotter pin (E) on the left side of the flatbed.
Slide out the pins to remove.
Use the longer pin on the left hinge.Move the control panel to the upright position, and then lift the flatbed to remove it from the printer.