CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.
Turn off the printer.
Unplug the power cord from the electrical outlet, and then from the printer.
Unpack the hard disk, and then remove the bracket.
Warning—Potential Damage: Do not touch or press the center of the hard disk.
Remove the hard disk cover.
Remove the controller board shield.
Insert the hard disk connector cable to the controller board compartment.
Position the hard disk over the mounting holes, and then press until it clicks into place.
Attach the hard disk cover.
Connect the hard disk connector cable to the controller board.
Attach the controller board shield.
Connect the power cord to the electrical outlet, and then turn on the printer.
CAUTION—POTENTIAL INJURY: To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.