Skip to Content Information Center
Lexmark CS639

Lexmark CS639

Not your product?

Installing the intelligent storage drive

CAUTION—SHOCK HAZARD:  To avoid the risk of electrical shock, if you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

  1. Turn off the printer.

  2. Unplug the power cord from the electrical outlet, and then from the printer.

  3. Using a flat‑head screwdriver, remove the controller board shield.

    Warning—Potential Damage:  Controller board electronic components are easily damaged by static electricity. Touch a metal surface on the printer before touching any controller board components or connectors.

  4. Unpack the intelligent storage drive (ISD).

    Warning—Potential Damage:  Avoid touching the connection points along the edge of the card.

  5. Locate the ISD connector.

  6. Insert the storage drive to the ISD connector.

  7. Attach the controller board shield, and then install the screws.

  8. Connect the power cord to the printer, and then to the electrical outlet.

    CAUTION—POTENTIAL INJURY:  To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.

  9. Turn on the printer.
Was this article helpful?


Related content

Top