Display Language - [List of languages]
| Set the language of the text that appears on the display. |
Country/Region - [List of countries or regions]
| Identify the country or region where the printer is configured to operate. |
| Run the setup wizard. |
| Select a language as a keyboard type. Note: All the Keyboard Type values may not appear or may require special hardware to appear. |
Displayed information - Display Text 1 (IP Address*)
- Display Text 2 (Date/Time*)
- Custom Text 1
- Custom Text 2
| Specify the information to appear on the home screen. |
Date and Time - Configure
- Current Date and Time
- Manually Set Date and Time
- Date Format (MM‑DD‑YYYY*)
- Time Format (12 hour A.M./P.M.*)
- Time Zone
- UTC (GMT) Offset
- DST Start
- DST End
- DST Offset
- Network Time Protocol
- Enable NTP (On*)
- NTP Server
- Enable Authentication (None*)
- Key ID
- Password
| Configure the printer date and time and network time protocol. Notes: - MM‑DD‑YYYY is the U.S. factory default setting. DD-MM-YYYY is the international factory default setting.
- UTC (GMT) Offset, DST Start, DST End, and DST Offset appear only when Time Zone is set to (UTC+user) Custom.
- Key ID and Password appear only when Enable Authentication is set to MD5 key.
|
| Specify the unit of measurement for paper sizes. Note: The country or region selected in the initial setup wizard determines the initial paper size setting. |
Screen Brightness - 20–100% (100*)
| Adjust the brightness of the display. |
Flash Drive Access - Disabled
- Enabled*
| Enable access to the flash drive. |
Allow Background Removal - Off
- On*
| Specify whether background removal is allowed. |
Allow Custom Job scans - Off
- On*
| Specify whether the Custom Job Scanning setting appears for copy, scan, and fax. Note: This menu item appears only when a hard disk or an intelligent storage drive is installed. |
| Set the printer to scan any type of job involving the scanner glass as a single page. Note: The printer returns to the home screen after performing a single flatbed scan instead of displaying prompts. |
Device Sounds - Mute All Sounds (Off*)
- Button Feedback (On*)
- Volume (5*)
- ADF Loaded Beep (On*)
- Alarm Control (Single*)
- Cartridge Alarm (Off*)
- Speaker Mode (Always Off*)
- Ringer Volume (Off*)
| Configure the sound settings of the printer. |
Screen Timeout - 5–300 seconds (60*)
| Set the idle time in seconds before the display shows the home screen, or before the printer logs out a user account automatically. |