Note: There are two types of deskew rollers used on this printer. The solid rubber roll use C-clips to fasten the deskew roller. Printers using the segmented rubber roller use E-clips to fasten the deskew roller. The parts are not interchangeable. Use both rollers when replacing this part.
Open the front door.
Remove the right cover. See Right cover removal.
Remove the left cover. See Left cover removal.
Remove the LVPS cage. See LVPS cage removal.
Remove the sensor (media type). See Sensor (media type) removal.
Remove the sensor (input). See Sensor (input) removal.
On the right side of the printer, remove the gear (A), and then remove the screw (B).
Remove the C‑clip (C), and then remove the spacer.
Warning—Potential Damage: Be careful not to over extend the clip when removing or installing to avoid damage.
Remove the bracket (D), and then unhook the spring (E).
Remove the spacer (F).
Remove the screw (G), and then remove the guide (H).
Remove the C‑clip (J), and then remove the bushing.
Remove the C‑clip (K), and then remove the spacer.
Remove the spring (L), and then remove the spacer (M).
Remove the screw (N), and then remove the guide (P).
Remove the C‑clip (Q), and then remove the bushing.
Slide the front deskew roller to the right to remove.
Note: Be careful not to drop or lose the washer on the left side of the shaft.
Slide the rear deskew roller to the right to remove.